Subject: | Front Floor Carpet Wet (Seal Top of "A" Pillar) |
Models: | 2004-2006 Buick Rainier |
2002-2006 Chevrolet TrailBlazer, TrailBlazer EXT |
2002-2006 GMC Envoy, Envoy XL |
2004-2005 GMC Envoy XUV |
2002-2004 Oldsmobile Bravada |
2005-2006 Saab 9-7X |
This bulletin is being revised to add a model year. Please discard Corporate Bulletin Number 03-08-57-004B (Section 08 -- Body and Accessories).
Some customers may comment that the front floor carpet is wet.
Water may enter a hole in the seam sealer at the roof panel to upper "A" pillar post. Refer to the illustration above. In this case, the water enters the hole and leaks down the inside of the "A" pillar and ends up on the front floor. Refer to the illustration above.
Water may enter the seam at the top of the "A" pillar. Refer to the illustration above. In this case, the water enters where the roof panel to upper "A" pillar meet and follows this seam under the windshield urethane. The water then drips onto the "A" pillar garnish molding and ends up on the floor. Refer to the illustration above.
There may be a lack of sealer under the "A" pillar reveal molding push nuts. Refer to the illustration above.
The push in retainers at the base of the auxiliary weatherstrip may not be seated fully. Refer to the illustration above.
There may be a gap between the many pieces of sheet metal under the primary seal flange. If this is present, water may enter under the primary seal retainer and into the vehicle between the gaps in the sheet metal flange and end up under the carpet. Refer to the illustration above.
Remove the auxiliary seal and the auxiliary seal retainer. Clean the surface and fill the void with Medium Body Seam Sealer, P/N 12378500 (in Canada, P/N 10952233). Let stand for 60 minutes and touch up.
Remove the auxiliary seal and the auxiliary seal retainer. Clean the area with a non oil base cleaner and fill the void with urethane sealer.
Install four new plastic nuts in the "A' Pillar. The new nuts have a foam gasket that seals the perimeter when seated.
Seat the push in retainers fully at the bottom of the "A" pillar.
Apply weatherstrip adhesive inside the primary seal retainer. Seal the retainer from the top of the dash to the bottom of the "A" pillar.
Part Number | Description |
---|---|
15004006 | Nut (1 per package) |
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
---|---|---|
C9991 | Waterleak Repair | 0.3 hr |
Add: | To Repair Other side | 0.2 hr |
For vehicles repaired under warranty, use:
Labor Operation | Description | Failed Object | Fault/Reason Code | Location Code | Warranty Type | Repair/Action Code | Labor Time |
---|---|---|---|---|---|---|---|
8133101 | Water Leak Repair | 81331 | 56 | 3-left, 4-right or 5-more than one side | 01 | 05 | 0.3 hr |
Add | To Repair Other side | -- | -- | -- | -- | -- | 0.2 hr in 99 time |