GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saab 🢒 2006 🢒 9-7x 🢒 Body 🢒 Body Front End 🢒 Hood Primary Latch Release Cable Replacement

Removal Procedure
  1. Remove the left front door sill plate. Refer to Front Side Door Sill Plate Replacement in Interior Trim.
  2. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.
  3. Loosen the hood close out filler panel. Refer to Front Bumper Upper Fascia Replacement .
  4. Remove the hood latch. Refer to Hood Primary and Secondary Latch Replacement .

    5. Object Number: 742161 Size: SH
  5. Release the hood latch release cable from the hood latch assembly.
  6. Attach a length of mechanic's wire to the exterior end of the cable, and note the routing of the cable for later installation.
  7. Release the retainers securing the cable to the inner fender.
  8. Feed the cable out from between the headlamp housing panel and the radiator.

    9. Object Number: 740669 Size: SH
  9. Push the cable grommet (1) through the bulkhead and into the interior of the vehicle.
  10. Remove the nut (2) attaching the hood release handle (3) to the cowl trim panel on the left side.
  11. Remove the cable from the release handle (3).
  12. Pull the cable the rest of the way through the cowl panel and out from behind the sound insulation.
  13. Detach the mechanic's wire from the cable, leaving the wire in position for aid in installation of the cable.
  14. Remove the cable from the vehicle.

Installation Procedure

    Object Number: 740669 Size: SH
  1. Attach the mechanic's wire to the exterior end of the cable.
  2. Using the mechanic's wire as an aid, guide the cable underneath the sound insulation and pass the exterior portion of the cable through the cowl panel.
  3. Install the cable to the release handle (3).
  4. Seat the cable grommet (1) to the cowl panel.
  5. Install the release handle (3) to the left side kick panel.

    6. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the nut (2) that retains the release handle (3) to the left side kick panel.

    7. Tighten
    Tighten the nut to 7 N·m (62 lb in).


    Object Number: 742161 Size: SH
  7. Route the cable as previously noted, between the headlamp housing panel and the core support.
  8. Attach the cable to the retainers on the inner fender.
  9. Install the cable to the hood latch assembly.
  10. Install the hood latch. Refer to Hood Primary and Secondary Latch Replacement .
  11. Install the grille. Refer to Grille Replacement in Exterior Trim.
  12. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.
  13. Install the hood close out filler panel. Refer to Front Bumper Upper Fascia Replacement .
  14. Install the left front door sill plate. Refer to Front Side Door Sill Plate Replacement in Interior Trim.
  15. Inspect the hood for proper alignment.