For 1990-2009 cars only
Removal Procedure
- Disconnect the rear washer hose connection (2) near the coolant tank.
- Remove the washer hose grommet (1) from the hole in the bulkhead, and feed the washer hose into the vehicle.
- Remove the right front sill plate. Refer to Rear Side Door Sill Plate Replacement . Roll the carpet inward to expose the wiring harness/hose assembly.
- Remove the rear seat backs.
- Remove the rear compartment anchors.
- Roll the carpet forward to expose the wiring harness/hose assembly.
- Remove the left rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement .
- Open the liftgate to access the pass-through grommet.
- Disconnect the grommet from the liftgate to access the washer hose connection.
- Cut the exposed ends of the washer hose from the body wiring harness.
- Remove the hose from the vehicle.
Installation Procedure
- Install the new washer hose to the vehicle.
- Route the hose along the body wiring harness in the same location as the old one was removed.
- Tape the washer hose to the body wiring harness with 3 wraps of electrical tape, every 100 mm (4 in) to ensure the same washer hose position.
- Roll the carpet back into place along the floor panel.
- Install the rear compartment anchors.
- Install the rear seat backs.
- Install the right front sill plate. Refer to Rear Side Door Sill Plate Replacement .
- Connect the washer hose connection at the liftgate.
- Connect the pass-through grommet the liftgate.
- Install the left rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement .
- Install the rear washer hose out through the bulkhead, and seat the grommet (1).
- Connect the rear washer hose connection (2) near the coolant tank.
