Circuit Description
The liftgate module (LGM) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensor has its own unique identification code contained within its RF transmission. These ID codes must be learned into the LGM memory to eliminate all other random RF transmissions from being received by the LGM.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0775 Low Tire Pressure System Sensors Not Programmed/Learned
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
No tire pressure sensor ID codes have been learned into the LGM memory.
Action Taken When the DTC Sets
| • | DTC C0775 is stored in memory. |
| • | The driver information center (DIC) displays the SERVICE TIRE MONITOR warning message. |
Conditions for Clearing the DTC
| • | A current DTC will clear when the sensor ID codes have been learned into the LGM memory. |
| • | A history DTC will clear after 100 consecutive malfunction-free ignition cycles from when the sensor ID codes have been learned into the LGM memory. |
| • | Using a scan tool. |
Diagnostic Aids
A newly replaced LGM will set DTC C0775 on its initial ignition ON cycle.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Learn the tire pressure sensors. Refer to Tire Pressure Sensor Learn . Did you complete the procedure? | Go to Step 3 | -- |
3 |
Does the DTC reset? | Go to Step 2 | System OK |
