DTC Descriptor
DTC P0495: Cooling Fan Speed HighDiagnostic Fault Information
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Relay Ground | -- | P0483, P0493 | -- | -- |
Relay Voltage Supply | P0480, P0483, P0493 | P0480, P0483, P0493 | -- | -- |
Relay Control | P0480 | P0480 | P0480 | -- |
Speed Sensor Low Reference | -- | P0483, P0493, P0526 | -- | -- |
Speed Sensor 5-Volt Reference | -- | P0526 | -- | -- |
Speed Sensor Signal | P0526 | P0526 | P0526 | -- |
Clutch Ground | -- | P0483, P0493 | -- | -- |
Clutch Voltage Supply | P0483, P0493 | P0483, P0493 | P0483, P0493, P0495 | -- |
Circuit/System Description
The cooling fan relay sends a pulse width modulation (PWM) signal, 12-14 volts, to the cooling fan by the cooling fan clutch supply voltage circuit. The control module uses the PWM signal, which controls the speed of the cooling fan clutch by controlling the position of the oil control valve inside the clutch. If the cooling fan clutch RPM is to high when the control module is commanding 0 percent, DTC P0495 will set.
Conditions for Running the DTC
| • | The engine is running. |
| • | The system voltage is greater than 8.5 volts. |
| • | The intake air temperature (IAT) is greater than -7°C (+19°F). |
| • | Zero percent duty cycle is commanded, and the engine RPM has been over 1,800 RPM for at least 120 seconds. |
Conditions for Setting the DTC
The cooling fan RPM exceeds 1,600 RPM for 81 seconds.
Action Taken When the DTC Sets
DTC P0495 is a Type B DTC.
Conditions for Clearing the DTC
DTC P0495 is a Type B DTC.
Reference Information
Schematic Reference
Connector End View Reference
| • | Powertrain Control Module Connector End Views for the 4.2L engine |
| • | Engine Control Module Connector End Views for the 5.3L engine |
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Circuit/System Verification
Engine OFF, verify the fan clutch is not binding by turning the fan by hand.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the fan shroud.
- Operate the engine at 2,000 RPM for 2 minutes. The fan should be quiet to indicate the clutch is disengaged.
| ⇒ | If disengaged, test or replace the relay. |
| ⇒ | If not disengaged, test the cooling fan clutch supply voltage circuit for a short to voltage. If the circuit tests normal, replace the clutch. |
Component Testing
Relay Test
- Connect the relay ground terminal to ground and the voltage supply terminal to appropriately fused power to energize the relay.
- Test for less than 1 volt between the load voltage supply terminal and ground.
- Connect the relay control circuit terminal to ground.
- Test for B+ between the load voltage supply terminal and ground.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for replacement, setup, and programming |
