Preliminary Procedures

1. Open the hood.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the wheelhouse panels from the left and right sides. Refer to Wheelhouse Panel Replacement .

1

Hood Filler Close Out Panel Retainers (Qty: 2)

2

Hood Filler Close Out Panel Screws (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tip
Filler close out panel is part of the fascia.

Tighten
2 N·m (18 lb in)

3

Front Fascia Extension Screws (Qty: 5)

Tip
The screws are located across the bottom of the fascia extension.

Tighten
2 N·m (18 lb in)

4

Front Fascia Extension

Tip
Pull forward to release the extension from the upper retainers.

5

Front Fog Lamp Bezels (Qty: 2)

6

Front Bumper Lower Fascia Retainers (Qty: 2)

Tip
One in each lower corner of the fascia.

7

Front Bumper Upper Fascia

Tip
The fascia upper corners are retained by push snap retainers. Grabbing the inside corner of the fascia and pull forward to until fully released.

8

Front Bumper Grille Bezel

Refer to Grille Replacement .

9

Front Fog Lamps

Refer to Front Fog Lamp Replacement .

10

Front Bumper Lower Fascia Bracket Rivets (Qty: 4)

Tip
It will be necessary to drill out the rivets that attach the bracket to the fascia.

11

Front Bumper Lower Fascia Brackets (Qty: 2)

12

Front Bumper Lower Fascia Rivets (Qty: 16)

Tip
It will be necessary to drill out rivets that attach the upper fascia to the lower fascia.

13

Front Bumper Lower Fascia