For 1990-2009 cars only
- Loosen the jam nut on the outer tie rod (2).
- Rotate the inner tie rod (1) to the required toe specification setting. Refer to Wheel Alignment Specifications.
- Tighten the jam nut on the outer tie rod to 75 N·m (55 lb ft).
- Check the toe setting after tightening.
- Re-adjust the toe setting if necessary.
Caution: Care must be taken that the boots are not twisted when rotating the inner tie rods, or damage to the boots may result.
Caution: Refer to Fastener Caution in the Preface section.
