GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saab 🢒 2009 🢒 9-7x 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Memory Seat Control Module Replacement

Removal Procedure
  1. Remove the 3 seat switch bezel screws. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement.

    2. Object Number: 752864 Size: SH
  2. Remove 4 nuts that attach the seat pan to the seat assembly.
  3. Remove the clip from the front outboard seat pan stud. Discard the clip.
  4. Lift the seat pan up in order to allow access to the seat control module retaining screw.

    5. Object Number: 752957 Size: SH
  5. Remove the seat control module retaining screw.
  6. Disconnect the electrical connectors from the seat control module as necessary.
  7. Remove the seat control module from the seat assembly.

Installation Procedure
  1. Align and install the locating tabs on the seat control module with the seat pan.
  2. Connect the electrical connectors to the seat control module as necessary.

    3. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 752957 Size: SH
  3. Install the screw that retains the seat control module to the seat pan and tighten to 3 N·m (26 lb in).
  4. Install the seat pan to the seat assembly.

    5. Object Number: 752864 Size: SH
  5. Install the nuts which retain the seat pan to the seat assembly and tighten to 25 N·m (18 lb ft).
  6. Install the 3 seat switch bezel screws. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement.
  7. Calibrate the seat. Refer to Memory Seat Calibration.