For 1990-2009 cars only
Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling.
- Remove the passenger side instrument panel (I/P) access panel.
- Remove the passenger air duct extension screw (1).
- Remove the air duct extension from the front of the I/P.
- Open the I/P compartment door to a full down position.
- Remove the 2 lower passenger supplemental inflatable restraint (PSIR) inflator module retaining bolts (1).
- Remove the 2 side retaining nuts from the PSIR inflator module.
- Remove the PSIR inflator module from the front of the I/P carrier.
- Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.
Warning: Refer to SIR Warning in the Preface section.
Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.
Installation Procedure
- Install the PSIR inflator module to the front of the I/P carrier.
- Install the 2 side retaining nuts to the PSIR inflator module.
- Install the 2 retaining bolts (1) to the PSIR inflator module.
- Install the passenger air duct extension though the front of the I/P.
- Install the passenger air duct extension screw (1) and tighten to 2.5 N·m (22 lb in).
- Close the I/P compartment door.
- Install the passenger side I/P access panel.
- Enable the SIR System. Refer to SIR Disabling and Enabling.
Caution: Refer to Fastener Caution in the Preface section.
Tighten the nuts until fully driven, seated and not stripped.
Tighten the bolts until fully driven, seated and not stripped.
