Rear Axle Housing Cover and Gasket Replacement 9.5 Inch Axle LD

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



2. Remove the drain plug.



3. Remove the rear axle cover bolts (1).
4. Remove the axle housing cover (2).
5. Remove the gasket (3).

Note: The axle housing gasket is reusable. Replace only if damaged.

1. Install the axle housing cover gasket (3).
2. Install the axle housing cover (2).

Caution: Refer to Fastener Caution in the Preface section.

3. Install the mounting bolts (1) and tighten to 40 N·m (30 lb ft).



4. Install the drain plug and tighten to 33 N·m (24 lb in).
5. Fill the rear axle with fluid.

Specification
The lubricant level should be between 0-13 mm (0-0.5 inch) below the fill plug opening.

6. If the level is low, add lubricant until the level is even with the bottom of the fill plug opening. Use the proper fluid, refer to Fluid and Lubricant Recommendations.
7. Lower the vehicle.

Rear Axle Housing Cover and Gasket Replacement 8.6 Inch Axle

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Drain the rear axle. Refer to Rear Axle Lubricant Level Inspection.
3. Remove the rear axle housing cover bolts (1).

Note: Do not nick or cut the rear axle housing cover gasket.

4. Remove the rear axle housing cover (2) from the axle housing.
5. Drain the axle lubricant into a suitable container.

1. Inspect the rear axle cover gasket for nicks, cuts or damage that may cause the gasket to not seal properly. If any of these conditions exist, replace the gasket.
2. If the gasket is to be reused, clean the rear axle housing cover gasket a suitable cleaner.
3. Clean the rear axle housing cover gasket surface and the rear axle housing gasket surface with a suitable cleaner.



4. Install the rear axle housing cover gasket and the rear axle housing cover (2).

Caution: Refer to Fastener Caution in the Preface section.

5. Install the rear axle housing cover bolts (1).

•	For the 8.0 inch axle, tighten the rear axle housing cover bolts in a crosswise pattern to 30 N·m (20 lb ft).

•	For the 8.6 inch axle, tighten the rear axle housing cover bolts in a crosswise pattern to 25 N·m (18 lb ft).

6. Fill the rear axle with axle lubricant. Use the proper fluid. Refer to Rear Axle Lubricant Level Inspection.
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.