Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1259: Antenna Ground CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Left Audio Signal (+) | 1 | 1 | 1 | -- |
Right Audio Signal (+) | 2 | 2 | 2 | -- |
Audio Common (-) | 3 | 3 | 3 | -- |
Digital Radio Antenna Coax | B1259* | B1259* | B1259* | -- |
1. No or distorted audio from left side speakers when listening to digital radio 2. No or distorted audio from right side speakers when listening to digital radio 3. No or distorted audio from all speakers when listening to digital radio *. Poor or no digital radio reception | ||||
Circuit/System Description
The digital radio receiver (DRR) receives XM satellite radio signals via a digital radio antenna located on the outside of the vehicle. The signal is passed to the DRR through digital radio antenna coax. From the DRR, one audio common (-) and separate left and right audio signals (+), are sent to the radio. The radio processes these signals and passes the audio to the appropriate speakers or audio amplifier.
Diagnostic Aids
When diagnosing digital radio concerns, the vehicle should be located outside with an unobstructed view of the southern sky to ensure proper reception of the satellite signal. Reception may limited, intermittent or not possible inside structures or under heavy cover.
Conditions for Running the DTC
Ignition is ON
Conditions for Setting the DTC
The DRR detects an antenna fault.
Action Taken When the DTC Sets
The radio displays No XM Signal
Conditions for Clearing the DTC
| • | A current DTC will clear when the conditions for setting the DTC are no longer present |
| • | A history DTC clears after 100 malfunction-free ignition cycles |
Reference Information
Schematic Reference
Radio/Navigation System Schematics
Connector End View Reference
Description and Operation
Radio/Audio System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Special Tools
EL-48028 Digital Radio Test Antenna
Circuit System Verification
With the vehicle outside in an area with an unobstructed view of the southern sky, tune to XM. Verify XM reception is clear and the No XM Signal message is not displayed on the radio.
Circuit/System Testing
- Ignition OFF, disconnect the antenna coax from the DRR. Connect the EL-48028 to the DRR.
- Ignition ON, radio tuned to XM, verify verify DTC B1259 is not set as current.
- Ignition OFF, reconnect the antenna coax to the DRR, disconnect the digital radio antenna coax from the digital radio antenna.
- Ignition ON, test for 4.5-5.5 volts between the antenna coax center terminal and the coax outer shield.
- If all circuits test normal, replace the digital radio antenna.
| ⇒ | If the DTC is current, replace the DRR. |
| ⇒ | If not within the specified range, replace the antenna coax. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for DRR replacement, setup, and programming |
