Air Cleaner Assembly Replacement 1st Design

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
2. Disconnect the engine wiring harness electrical connector (1) from the mass airflow (MAF)/intake air temperature (IAT) sensor.



3. Remove the air cleaner housing rear bolt.
4. Reposition the air conditioning (A/C) condenser and evaporator tube clamp as required.



5. Remove the A/C compressor and condenser line clip (2) from the air cleaner tab (1).



6. Remove the air cleaner assembly from the upper tie bar.

1. Install the air cleaner assembly to the upper tie bar.



2. Install the A/C compressor and condenser line clip (2) to the air cleaner tab (1).



3. Position the A/C condenser and evaporator tube clamp as required.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the air cleaner housing rear bolt.

Tighten
Tighten the bolt to 10 N·m (89 lb in).




5. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .