GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1774876  Size: SH
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the evaporative emission (EVAP) canister purge solenoid.

  3. Object Number: 1774990  Size: SH
  4. Disconnect the EVAP pipe quick connect fitting (2) from the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .

  5. Object Number: 1775003  Size: SH
  6. Remove the EVAP canister purge solenoid bolt (1).
  7. Remove the EVAP canister purge solenoid (2) from the upper intake manifold.
  8. Remove and discard the EVAP canister purge solenoid O-ring seal (3).

Installation Procedure


    Object Number: 1775003  Size: SH
  1. Install a NEW EVAP canister purge solenoid O-ring seal (3) to the upper intake manifold.
  2. Install the EVAP canister purge solenoid (2) to the upper intake manifold.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the EVAP canister purge solenoid bolt (1).
  5. Tighten
    Tighten the bolt to 16 N·m (12 lb ft).


    Object Number: 1774990  Size: SH
  6. Connect the EVAP pipe quick connect fitting (2) to the EVAP canister purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .

  7. Object Number: 1774876  Size: SH
  8. Connect the engine wiring harness electrical connector (1) to the EVAP canister purge solenoid.
  9. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .