GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Theft Deterrent System Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, command the security indicator ON.

Does the security indicator turn ON and OFF when commanded?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

3

Disconnect the body control module (BCM) connector containing the security indicator control circuit.

Does the security indicator remain illuminated?

Go to Step 4

Go to Step 5

4

Test for a short to ground in the security indicator control circuit. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 8

Go to Step 6

5

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 8

Go to Step 7

6

Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 8

--

7

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 8

--

8

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3