Diagnostic Instructions
Circuit/System Description
The keyless entry system is a vehicle entry device. The keyless entry will unlock/unlatch the vehicle doors or open the rear gate when a corresponding button on the key fob is pressed. This is accomplished by the key fob sending a radio frequency to the
remote control door lock receiver (RCDLR). The signal is received by the RCDLR via an internal antenna located within the RCDLR. The RCDLR interprets the signal and activates the requested function via a message over the GMLAN serial data line. A low transmitter
battery or radio frequency (RF) interference from aftermarket devices such as 2-way radios, power inverters, cellular phone chargers, computers, etc. may cause a system malfunction. High RF traffic areas, such as gas stations which use pay-at-the-pump RF transponders,
may also cause interference that could lead to a malfunction.
Diagnostic Aids
For the
J 43241
Keyless Entry Tester, inspect the keyless entry transmitter part number to determine that it is the correct model for the vehicle. A wrong model transmitter may pass the test, but it
will not activate the vehicle remote system.
Reference Information
Schematic Reference
Remote Function Schematics
Connector End View Reference
Remote Function Connector End Views
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Scan Tool Reference
Scan Tool Data List
Special Tools Required
J 43241
Keyless Entry Tester
Circuit/System Testing
- Verify that the transmitter is the correct transmitter for the vehicle.
⇒ | If not the correct transmitter, replace the transmitter. |
- Verify the scan tool FOB Programmed parameter is Yes.
⇒ | If not Yes, program the transmitter. |
- Place the transmitter on the test pad of the
J 43241
and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
⇒ | If none of the buttons sounds the tone and illuminates the green light, replace the battery. |
⇒ | If one or more of the buttons sounds the tone and illuminates the green light, replace the transmitter. |
- Verify the scan tool FOB Function parameter responds to every function on the transmitter.
⇒ | If it does not respond to every function, replace the RCDLR module. |
- Replace the transmitter.
Repair Instructions
Important: This vehicle may be equipped with the Advance 2 Way Remote Start System. Vehicle equipped with the Advance 2 Way Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label
on the RCDLR. When servicing the Advance 2 Way Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the Advance 2 Way Remote Start System can be found in the Accessory section of the parts manual.
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.