Preliminary Procedures

1. Place the rear door window in the fully down position.
2. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .

1

Rear Door Window Regulator Retaining Pin

Procedure

1. Remove the rear door water deflector.
2. Position the window to view the window to regulator retaining pin.
3. Use a suitable tool, insert the tool through the upper slot 1 in the window regulator arm and through the window guide releasing the window.
4. Tape the window to the up door frame to keep in place.

2

Rear Door Window Regulator Bolt (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
10 N·m (89 lb in)

3

Rear Door Window Regulator

Procedure

Disconnect the electrical connector.