Preliminary Procedures

1. Remove the fuse labeled HVAC CTRL (BATT).
2. Remove the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
3. Remove the knee bolster. Refer to Knee Bolster Replacement .
4. Disconnect the mode actuator electrical connector.

1

Mode Actuator Screw (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
1.5 N·m (13 lb in)

2

Mode Actuator

Tip

1. Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.
2. Refer to Control Module References for programming and set up information.