Preliminary Procedure

Remove the instrument panel (I/P) center molding. Refer to Instrument Panel Center Molding Replacement .

1

Heater and Air Conditioning Control Assembly Screw (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tip

1. The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
2. Disconnect the heater and air conditioning control assembly electrical connectors.

Tighten
1.5 N·m (13 lb in)

2

Heater and Air Conditioning Control Assembly

Tip
Refer to Control Module References for programming and set up information.