Caution: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Caution: Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.

Note: DO NOT prop open the throttle blade with the ignition key in the ON position as it may set a diagnostic trouble code (DTC).

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
2. Disconnect the engine wiring harness electrical connector (2) from the electronic throttle control (ETC) (1).



3. Remove the throttle body bolts.
4. Remove the throttle body.
5. Inspect the throttle body gasket, and replace if necessary.

1. Install the throttle body.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the throttle body bolts and tighten to 10 N·m (89 lb in).



3. Connect the engine wiring harness electrical connector (2) to the ETC (1).
4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
5. Perform the Throttle Learn procedure. Refer to Throttle Learn.