Special Tools

J 39400-A Halogen Leak Detector

Note: Refrigerant recovery is not required.




1. Remove the refrigerant pressure sensor wire harness connector.
2. Remove the refrigerant pressure sensor.
3. Remove and discard the O-ring.

1. Install a new O-ring. Refer to O-Ring Replacement.

Caution: Refer to Fastener Caution in the Preface section.

2. Install the refrigerant pressure sensor and tighten to 5 N·m (44 lb in).



3. Install the refrigerant pressure sensor wire harness connector.
4. Leak test the fittings using the J 39400-A .