Special Tools

J 45059 Angle Meter

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.



3. Disconnect the ABS routing harness connectors (1) and position the harness aside. Note the routing for assembly.



4. Remove the upper control arm to support assembly bolt and nut.



5. Remove the upper control arm to knuckle bolt and nut.
6. Remove the upper control arm from the vehicle through the wheelhouse opening.

1. Position the upper control arm to the support assembly and knuckle through the wheelhouse opening.
2. Install the upper control arm to knuckle bolt and nut. Hand tighten only.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the upper control arm to support assembly bolt.

Tighten

•	Tighten the upper control arm to support assembly bolt to 60 N·m (44 lb ft). Using the J 45059 , rotate an additional 60 degrees.

•	Tighten the upper control arm to knuckle bolt to 110 N·m (81 lb ft). Using the J 45059 , rotate an additional 70 degrees.




4. Route the harness and connect the ABS routing harness connectors (1).
5. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
6. Lower the vehicle.