GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

   • The seat cushion frame
   • The seat recliner, if equipped
   • The seat adjuster
   • The seat back frame
Failure to do so may cause future personal injury.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling.

  2. Object Number: 1506502  Size: SH

    Note: Removal of the right or the left inflatable restraint side impact module uses the same procedure.

  3. Remove the seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement.

  4. Object Number: 1506506  Size: SH
  5. Remove the nuts from the inflatable restraint side impact module.
  6. Remove the module from the seat.
  7. Remove the connector position assurance (CPA) from the module electrical connector.

  8. Object Number: 792283  Size: SH
  9. Disconnect the electrical connector (1) from the module.

Installation Procedure


    Object Number: 792283  Size: SH
  1. Connect the electrical connector (1) to the inflatable restraint side impact module.
  2. Install the CPA to the module electrical connector.

  3. Object Number: 1506506  Size: SH
  4. Install the inflatable restraint side impact module to the seat.
  5. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the nuts to the inflatable restraint side impact module and tighten to 10 N·m (89 lb in).

  7. Object Number: 1506502  Size: SH
  8. Install the seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling.
  10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.