GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2008 🢒 Astra 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 DTC C0060-C0095

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0060 00: Front Left Inlet Solenoid Valve Circuit Malfunction

DTC C0065 00: Front Left Outlet Solenoid Valve Circuit Malfunction

DTC C0070 00: Front Right Inlet Solenoid Valve Circuit Malfunction

DTC C0075 00: Front Right Outlet Solenoid Valve Circuit Malfunction

DTC C0080 00: Rear Left Inlet Solenoid Valve Circuit Malfunction

DTC C0085 00: Rear Left Outlet Solenoid Valve Circuit Malfunction

DTC C0090 00: Rear Right Inlet Solenoid Valve Circuit Malfunction

DTC C0095 00: Rear Right Outlet Solenoid Valve Circuit Malfunction

Circuit/System Description

The electronic brake control module (EBCM) commands the solenoid relay ON or OFF to open or close the valves in the BPMV.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC
    • The EBCM detects no change in voltage when commanding the solenoid valves ON.
    • The EBCM detects no change in voltage when commanding the solenoid valves OFF.

Action Taken When the DTC Sets
    • The EBCM disables the antilock brake system (ABS),traction control (TC),vehicle stability control for the duration of the ignition cycle.
    • If equipped the EBCM sends a serial data message to illuminate the warning indicator/message.

Conditions for Clearing the DTC
    • The condition for setting the DTC is no longer present.
    • The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation Reference

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs
    •  Connector Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Ignition ON, verify that DTC C0060, C0065, C0070,C0075, C0080, C0085, C0090 or C0095 is not set.

⇒ If any of the DTCs are set, replace the EBCM. If the DTC resets, replace the BPMV.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Brake Pressure Modulator Valve Replacement
    •  Control Module References for EBCM replacement, setup, and programming