Removal Procedure
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the battery.
- Wait 1 minute for airbag to deactivate.
Important: Ensure that the retaining wire is not bent.
- Remove the airbag.
• | Turn the steering wheel 90 degrees (I). |
• | Push the retaining wire in the direction of the steering column using a small screwdriver in the service opening (II) and remove the airbag module. |
• | Release and disconnect the wiring harness plug. |
Installation Procedure
- Install the airbag.
• | Connect and latch the wiring harness plug. |
- Perform a readiness inspection.
- Connect the battery.
- For programming procedures, refer to
Control Module References
.