GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2009 🢒 Astra 🢒 Engine 🢒 Engine Electrical 🢒 Starter Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1945790 Size: SH
  1. Open the hood.
  2. Disconnect the battery.
    3. • Remove the ground connection from the ground terminal.
    • Loosen the nut.
  3. Raise the vehicle by its full height.
  4. Remove the ground cable (1) from starter.

    5. Remove the nut.

  5. Remove the 2 positive cable (2) starter.

    6. Remove the 2 nuts.


    Object Number: 1945774 Size: SH
  6. Remove the intake manifold bracket (2).
    7. • Disconnect the wiring harness plug of the catalytic converter control oxygen sensor.
    • Disconnect the wiring harness plug (1) from the bracket.
    • Remove the 2 bolts (3).

    Object Number: 1945791 Size: SH
  7. Remove the starter.

    8. Remove the 2 bolts (1, 2).

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.

  1. Install the starter.

    2. Tighten
    Tighten the 2 bolts to 25 N·m (18 lb ft).

  2. Install the intake manifold bracket.

    3. Tighten
    Tighten the 2 bolts to 8 N·m (70 lb in).

    • Install the wiring harness plug into the bracket.
    • Connect the wiring harness plug for the catalytic converter control oxygen sensor.
  3. Install the wiring harness to the starter.

    4. Tighten
    Tighten the 2 nuts to 12.5 N·m (110 lb in).

  4. Install the ground cable to the starter.

    5. Tighten
    Tighten the nut to 12.5 N·m (110 lb in).

  5. Lower the vehicle by its full height.
  6. Connect the battery.

    7. Install the ground connection to the ground terminal.

    Tighten
    Tighten the nut to 12.5 N·m (110 lb in).

  7. For programming procedures, refer to Control Module References.
  8. Close the hood.