Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the battery.
- Remove the windshield garnish molding. Refer to
Windshield Garnish Molding Replacement.
- Remove the instrument panel (I/P) compartment.
⢠| Open the I/P compartment cover. |
⢠| Remove the 4 bolts (1). |
⢠| Disconnect the wiring harness plug. |
⢠| Remove the I/P compartment. |
- Remove the windshield antenna.
⢠| Remove the windshield antenna with a plastic wedge. |
⢠| Guide the wiring harness (1) with the antenna through the instrument panel padding. |
- Disconnect the antenna cable.
Installation Procedure
- Connect the cable.
- Install the windshield antenna.
⢠| Route the wiring harness through the I/P padding to the top of the A-pillar. |
⢠| Install the antenna in the left upper area of the windshield with adhesive. |
- Insert the I/P compartment.
Connect the wiring harness plug.
Caution: Refer to Fastener Caution in the Preface section.
- Fasten the I/P compartment.
Tighten
Tighten the 4 screws to 4 NĀ·m (35 lb in).
- Install the windshield garnish molding. Refer to
Windshield Garnish Molding Replacement.
- Connect the battery.
- For reprogramming procedures, refer to
Control Module References.