• | Remove the 2 front door retainer base inner paneling. |
• | Loosen the water vapor barrier in the area of the hatching. |
Remove the plastic retainer and release the fastening pins.
• | Remove the 3 bolts. |
• | Disconnect the connector linkage of the lock cylinder and remove the lock. |
Disconnect the cable from the bracket and take out of lock.
Push the cable back into lock and clip into bracket.
Caution: Refer to Fastener Caution in the Preface section.
Install the connector linkage of the lock cylinder and install the lock.
Tighten
Tighten the 3 bolts to 8 N·m (70 lb in).
Connect and latch the wiring harness plug.
Install the fastening pins and clip the plastic retainer.
Install the 2 front door retainer base inner paneling.