GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Note: 

   • If replacing the instrument cluster, check which version of the fuel tank fuel level sensor is installed.
   • When replacing the control unit, before removing the control unit, carry out a Reset using a scan tool. For reprogramming procedures, refer to Control Module References.

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the battery.
  2. Disconnect the negative battery cable.


    Object Number: 1936910  Size: LF
  3. Remove the lower steering column paneling.
  4. • Remove the 5 bolts (arrows).
    • Remove the ignition lock panel (1).

    Object Number: 1936913  Size: LF
  5. Remove the instrument cluster.
  6. • Remove the 2 bolts (1).
    • Disconnect the wiring harness plug.
    • Release the wiring harness plug and disconnect.
    • Remove the instrument cluster (3) with the upper steering column paneling (2).

    Object Number: 1936940  Size: SH
  7. Remove the upper steering column paneling (1) from the instrument cluster (2).

Installation Procedure

  1. Install the upper steering column paneling to the instrument cluster.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the instrument cluster.
  4. • Insert the instrument cluster with the upper steering column paneling.
    • Connect the wiring harness plug.

    Tighten
    Tighten the 2 screws to 2.5 N·m (22 lb in).

  5. Install the lower steering column paneling.
  6. • Fold down the upper steering column paneling.

    Tighten
    Tighten the 5 screws to 0.9 N·m (8 lb in).

    • Install the ignition lock panel.
    • Install the 2 screw head covers.
    • Insert knobs for the screen wiper switch and the indicator switch.
  7. Connect the battery.
  8. Connect the negative battery cable.

    Note: If replacing the instrument cluster, check which version of the fuel tank fuel level sensor is installed.

  9. For reprogramming procedures, refer to Control Module References.