Removal Procedure
- Remove the panel for the microphone (2) and the panel for the sliding sun roof control unit (3) using a suitable tool (flat-bladed tool).
- Remove the lens from the interior lamp (1).
- Remove the front interior lamp holder.
⢠| Remove the 2 bolts (1). |
⢠| Remove the holders (4) all around. |
⢠| Disconnect the wiring harness holder (2). |
⢠| Disconnect the wiring harness plug (3). |
- Remove the ultrasound sensor.
⢠| Disconnect the compact plug (1). |
⢠| Disconnect the wiring harness at the compact plug (arrow). |
⢠| Remove the panel with the ultrasonic sensors (2). |
- Remove the necessary lamps.
Remove the 2 bulbs.
Installation Procedure
- Install the necessary lamps.
Install the 2 bulbs.
- Install the ultrasound sensors.
⢠| Install the panel with the ultrasound sensors. |
⢠| Insert the wiring harness in the compact plug and lock. |
⢠| Connect in the compact plug. |
Caution: Refer to Fastener Caution in the Preface section.
- Install the front interior lamp holder.
⢠| Connect the wiring harness plug. |
⢠| Connect the wiring harness holder. |
⢠| Connect the holders all around. |
Tighten
Tighten the 2 screws to 1.5 NĀ·m (13 lb in).
- Install the lens for the interior lamp.
Install the 4 clips.
- Install the microphone panel and the panel for the sliding sun roof control unit.
Install the 2 panels.