GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the battery.
  2. Wait 1 minute for the airbag to deactivate.
  3. Remove the front floor console. Refer to Front Floor Console Replacement.

  4. Object Number: 1937614  Size: LH
  5. Remove the airbag control unit.
  6. Remove the 3 nuts (1) and remove the control unit.

  7. Loosen the airbag wiring harness.
  8. Release the 2 wiring harness plugs and disconnect.

Installation Procedure

  1. Fasten the airbag wiring harness.
  2. Connect and latch the wiring harness plug.

    Caution: Refer to Fastener Caution in the Preface section.

  3. Install the airbag control unit.
  4. • Connect 2 wiring harness plugs.

    Tighten
    Tighten the 3 nuts to 10 N·m (89 lb in).

  5. Install the front floor console. Refer to Front Floor Console Replacement
  6. Connect the battery.
  7. Note: When replacing the control unit, after installing the control unit, program with a scan tool.

  8. For programming procedures, refer to Control Module References.