For 1990-2009 cars only
Removal Procedure
- Lower the window.
- Remove the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement.
- Remove the rubber ring.
- Remove the water vapor barrier.
- Remove the belt inner sealing strip.
- Remove the belt outer sealing strip.
- Loosen the lower window channel (3).
- Remove the rear window channel seal (1).
- Remove the rear window channel (2).
- Remove the rear door window.
Pull the sealing strip carefully from behind beginning at the top.
Pull the sealing strip carefully from behind beginning at the top.
Remove the bolt.
Remove the bolt.
Remove the window from window channel.
Installation Procedure
- Install the window.
- Install the front door rear window channel.
- Tighten the rear lower window channel.
- Install the belt outer sealing strip.
- Install the belt inner sealing strip.
- Install the water vapor barrier.
- Install the weatherstrip.
- Install the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement.
- Close the window.
| • | Wind the window half way up. |
| • | Slide the window in the lower guide. |
Caution: Refer to Fastener Caution in the Preface section.
Tighten
Tighten the top bolt to 2.5 N·m (22 lb in).
Tighten
Tighten the bolt to 7 N·m (62 lb in).
Note: Damaged water vapor barrier must be replaced.
| • | Apply the adhesive tape to the door frame according to the shaded areas shown. |
| • | Cut the foil to size. |
| • | Provide the cut-outs for inside handle with bearing supports and, if available, manual window actuation. |
| • | Install the water vapor barrier without creases. |
