GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2009 🢒 Astra 🢒 Body Systems 🢒 Wipers and Washers 🢒 Windshield Washer Solvent Container Replacement

Removal Procedure

    Object Number: 1936331 Size: SH
  1. Remove the radiator grille.
    2. • Remove the 4 body-bound rivets.
      Release from the front paneling upward.
    • Release the 6 clips.

    Object Number: 1937525 Size: LH
  2. Release the solvent container at the top front.

    3. Remove the bolt (1).

  3. Release the solvent container at the base.

    4. Remove the 2 bolts (2).


    Object Number: 1937526 Size: LH

    Note: Drain the washer solvent into a suitable container.

  4. Remove the hoses and wiring harness plugs.

    5.    Note: Depending on vehicle design.

    • Disconnect the 3 wiring harness plugs (1, 2).

       Note: Depending on vehicle design.

    • Disconnect the 3 hoses (3, 4).
    • Unclip the 3 hoses.
    • Remove the solvent container downward.
    • Remove the wiring harness.

    Note: Depending on vehicle design.

  5. Remove the attachment.
    6. • Remove the pump for the front and rear screens.
    • Remove the pump for the headlamp washer system.
    • Remove the fill level sensor.
    • Bring the pin to vertical position for removal.

Installation Procedure

    Note: Depending on vehicle design.

  1. Install the attachments.
    2. • Install the pump for the front and rear screens.
    • Install the pump for the headlamp washer system.
    • Install the fill level sensor.
  2. Install the solvent container at the base.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the cable tie.

    4. Tighten
    Tighten the 2 screws to 3.5 N·m (31 lb in).

    Note: Depending on vehicle design.

  4. Install the hoses and the wiring harness plugs.
    5. • Connect the 3 wiring harness plugs.
    • Connect the 3 hoses.
  5. Install the solvent container at the top front.

    6. Tighten
    Tighten the bolt to 3.5 N·m (31 lb in).

  6. Install the radiator grille.
    7. • Insert the 4 body-bound rivets.
    • Install the front paneling downward.
    • Clip in the 6 clips.
  7. Top up the washer fluid.