Removal Procedure
- Tilt the steering column in the upper position.
- Remove the light switch center.
2.1. | Turn the light switch (1) to the left position and press in, then turn pressed switch to the middle position (3). |
2.2. | Remove the light switch center (2). |
- Remove the inner paneling for the driver side knee bolster.
3.2. | Disconnect and remove the driver knee bolster from the bracket. |
Installation Procedure
- Install the inner paneling for the driver side knee bolster.
Caution: Refer to Fastener Caution in the Preface section.
- Install the driver knee bolster into the lower bracket.
Tighten
Tighten the 4 bolts to 2.5 N·m (22 lb in).
- Install the light switch center.
3.1. | Connect and latch the wiring harness plug. |
3.2. | Insert the light switch center. |
3.3. | Turn the switch to the OFF position. |
3.4. | Tilt the steering column downwards. |