Headlamp Replacement with Dipped Beam
Removal Procedure
Warning: The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.
Warning: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:
• Never open the high intensity discharge system ballast or the arc tube assembly starter. • Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.
Warning: Refer to Halogen Bulb Warning in the Preface section.
Note: Warning, high voltage. Do not touch components in the xenon dipped beam when the dipped beam is switched on. Ignition and light switch OFF.
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
- Remove the fuse.
- Release the headlamp.
- Remove the headlamps.
- Remove the lights and the control units.
Remove the 3 screws (1, 2).
| • | Remove the connector. |
| • | Remove the headlamps. |
| • | Disconnect the wiring harness plug (3). |
Installation Procedure
- Install the lights and control units.
- Insert the headlamp.
- Install the headlamp.
- Insert the fuse.
- Install the front bumper fascia. Refer to Front Bumper Fascia Replacement.
- Adjust the headlamp.
| • | Connect the wiring harness plug. |
| • | Install the connector. |
Caution: Refer to Fastener Caution in the Preface section.
Install the connector.
Tighten
Tighten the 3 bolts to 2.5 N·m (22 lb in).
