For 1990-2009 cars only
Circuit Description
The steering column control module recognizes the malfunction of the circuit via an internal evaluation logic.
DTC Descriptor
DTC B2961: Switch Position Ignition Key Circuit Malfunction
Conditions for Running the DTCs
| • | Voltage supplied to the module is in the normal operating voltage range. |
| • | The vehicle power mode requires serial data communication to occur. |
Conditions for Setting the DTC
The control unit recognises the malfunction of the circuit via an internal evaluation logic.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Power Mode Description and Operation
Electrical Information Reference
Scan Tool References
Refer to Component Connector End Views for scan tool information.
Circuit/System Verification
- Verify DTC P0606 is not set as current.
- Verify DTC U2961 is not set .
| ⇒ | If DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle . |
| ⇒ | If DTC is set, replace the SCCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for SCCM replacement, setup, and programming
