GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Lower the molded headlining. Refer to Headlining Trim Panel Replacement.

  2. Object Number: 1941077  Size: SH
  3. Remove the power sunroof motor.
  4. 2.1. Remove the 3 bolts (1).
    2.2. Disconnect the wiring harness plug (2).

Installation Procedure

  1. Install the power sunroof motor.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Connect the wiring harness plug.
  4. Tighten
    Tighten the 3 bolts to 7 N·m (62 lb in).

  5. Install the molded headlining. Refer to Headlining Trim Panel Replacement.
  6. Note: Open and close the sliding sunroof fully.

  7. For programming procedures, refer to Control Module References.