Removal Procedure
- Remove wind protection weatherstrip (1).
- Remove windshield wiper arms (2).
2.1. | Remove the 2 cover caps. |
2.3. | Remove the 2 washers. |
2.4. | Pull the 2 windshield wiper arms from the shaft. |
Note: From the inside, carefully unlatch the clips from the upper bulkhead mounting.
- Detach the air inlet screen (1).
3.1. | Lever off the air inlet screen in the dash area. |
3.2. | Release the 5 clips (3). |
3.3. | Detach the windshield washer hose (2). |
Installation Procedure
- Install the air inlet screen.
1.1. | Attach the windshield washer hose. |
1.2. | Install the 5 clips. |
Caution: Refer to Fastener Caution in the Preface section.
Note: Make sure the windshield wiper arms are installed in the correct position.
- Install the windshield wiper arms.
2.1. | Connect the 2 windshield wiper arms to the shafts. |
2.2. | Install the 2 washers. |
Tighten
Tighten the 2 nuts to 17 N·m (13 lb ft).
2.3. | Install the 2 cover caps. |
- Install the wind protection weatherstrip.