For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B3109 00: Remote-Key 1 System Voltage Low VoltageDTC B3110 00: Remote-Key 2 System Voltage Low Voltage
DTC B3111 00: Remote-Key 3 System Voltage Low Voltage
DTC B3112 00: Remote-Key 4 System Voltage Low Voltage
DTC B3113 00: Remote-Key 5 System Voltage Low Voltage
Circuit/System Description
With each press of a remote-key button, a message containing the current battery state of the remote-key is sent to the steering column module (CIM) along with the commanded keyless entry function.
Conditions for Running the DTC
A remote-key button is pressed.
Conditions for Setting the DTC
The DTC sets after 3 consecutive low battery signals from the same programmed remote-key.
Action Taken When the DTC Sets
The keyless entry system is inoperative.
Conditions for Clearing the DTC
The DTC is cleared when a normal remote-key voltage signal is received from the programmed transmitter that set the DTC.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify none of the following DTCs are set:
| • | DTC B3109 |
| • | DTC B3110 |
| • | DTC B3111 |
| • | DTC B3112 |
| • | DTC B3113 |
| ⇒ | If any of the DTCs are set, replace the battery in the appropriate remote-key. Operate the remote-key 3 consecutive times. If the DTC resets, replace the remote-key. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
