Special Tools

J 39637 KM-6626 Wiper Arm Puller

Warning: Refer to Battery Disconnect Warning in the Preface section.

1. Disconnect the battery.



2. Remove the windshield air inlet screen (1).
3. Remove the wiper arms (2).

•	Remove the 2 covers.

•	Remove the 2 nuts.

•	Remove the 2 washers.

•	Remove the wiper arm using J 39637 / KM-6626.

•	Disconnect the hose for the washer/wiper system.




4. Remove the windshield air inlet screen (1).

•	Lift the windshield air inlet screen in the vicinity of the dash.

Note: Carefully release the clips from the inside from the upper dash.

•	Release the 5 clips (3).

•	Remove the hose for the air inlet screen (2).




5. Remove the power horn.

•	Disconnect the wiring harness plug (1).

•	Remove the 2 nuts (2).

•	Remove the power horn.

Caution: Refer to Fastener Caution in the Preface section.

1. Install the power horn.

•	Position the power horn.

Tighten
Tighten the 2 nuts to 5 N·m (44 lb in).

•	Connect the wiring harness plug.

2. Install the windshield air inlet screen.

•	Install the hose to the air inlet screen.

•	Install the 5 clips.

3. Install the windshield wiper arms.

Note: Ensure correct installation position of the windshield wiper arms.

•	Position the 2 windshield wiper arms on the shaft.

•	Install the 2 washers.

Tighten
Tighten the 2 nuts to 17 N·m (13 lb ft).

•	Install the 2 covers.

4. Install the windshield air inlet screen.
5. Connect the battery.
6. For reprogramming procedures, refer to Control Module References.