GM Service Manual Online
For 1990-2009 cars only

Tools Required

SA9156E Fuel Tank Lock Ring Remover, or J 39765 Fuel Sender Lock Nut Wrench

Removal Procedure

Caution: Refer to Gasoline/Gasoline Vapors Caution in the Preface section.

Caution: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket when reinstalling the fuel sender assembly.

  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Important: Take note of the positioning of the fuel tank rear shield prior to releasing the pump module pipe retainer.

  3. Release the retaining tab on the fuel tank retainer used to secure the fuel pump module pipes in position on the tank.
  4. Release the fuel pump module electrical harness from the retaining slot on the tank.

  5. Object Number: 889969  Size: SH
  6. Disconnect the fuel pump module harness electrical connector from the fuel tank pressure sensor.

  7. Object Number: 889980  Size: SH
  8. Using the SA9156E , or J 39765  (1), carefully rotate to release the fuel pump module retaining lock ring.

  9. Object Number: 889983  Size: SH
  10. Remove the fuel pump module retaining lock ring, by sliding the ring over the module pipes and electrical harness.

  11. Object Number: 889986  Size: SH
  12. Slowly raise the fuel pump module assembly until the fuel level sensor float arm is just visible. Ensure that the fuel level sensor harness connector clears the tank opening.
  13. Important: When removing the fuel pump module assembly from the fuel tank, be aware that the pump module reservoir bowl is full of fuel. The reservoir must be tipped slightly during removal to avoid bending the fuel level sensor float arm.

  14. Tilt the pump module toward the rear of the fuel tank to enable the level sensor float arm to clear the tank opening. Remove the pump module from the tank.
  15. Carefully discard the fuel in the pump module reservoir bowl into an approved fuel container.
  16. Important: Do NOT reuse the old fuel pump module-to-fuel tank seal.

  17. Remove and discard the fuel pump module-to-fuel tank seal (1).

Installation Procedure


    Object Number: 889986  Size: SH
  1. Install a NEW fuel pump module-to-fuel tank seal (1).
  2. Important: The reservoir must be tipped slightly during installation to avoid bending the fuel level sensor float arm.

  3. Tilt the pump module toward the rear of the fuel tank to enable the level sensor float arm to clear the tank opening. Install the fuel pump module to the fuel tank.
  4. Slowly lower the fuel pump module assembly into the tank. Ensure that the fuel level sensor harness connector is positioned properly.

  5. Object Number: 889983  Size: SH
  6. Install the fuel pump module retaining lock ring over the module pipes and electrical harness, and into position on the top of the module.

  7. Object Number: 889980  Size: SH

    Important: Ensure that the fuel pump module retaining lock ring is fully seated within the fuel tank retaining tab slots.

  8. Using the SA9156E , or J 39765  (1), carefully rotate to fully secure the fuel pump module retaining lock ring.

  9. Object Number: 889969  Size: SH
  10. Connect the fuel pump module harness electrical connector to the fuel tank pressure sensor.
  11. Secure the fuel pump module electrical harness into the retaining slot on the tank.
  12. Important: Ensure that the fuel tank rear shield is positioned properly on the pump module pipe retainer.

  13. Secure the retaining tab on the fuel tank retainer used to secure the fuel pump module pipes in position on the tank.
  14. Install the fuel tank. Refer to Fuel Tank Replacement .