For 1990-2009 cars only
- Remove the accelerator pedal retaining nuts. Move the pedal aside.
- With the brake pedal fully released, insert the stop lamp switch into the brake pedal bracket until the switch plunge is fully depressed into the barrel.
- Twist the switch clockwise until the travel stop has been reached.
- The plunger should extend out of the barrel (1) of the switch approximately 1.0 mm (0.04 in).
- Install the accelerator pedal to the dash panel. Install the retaining nuts
- Inspect the stop lamps for proper operation.
Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive brake lining wear.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the accelerator pedal retaining nuts to 10 N·m (89 lb in)
