DTC P1700 for Saturn ION 2003

Circuit Description

The transmission control module (TCM) uses the controller area network (CAN) to communicate with the engine control module (ECM). If the ECM detects that the TCM has set a non-emission related transmission code and is requesting the service vehicle soon (SVS) message on the driver information center (DIC), DTC P1700 sets.

Conditions for Running the DTC

•	The ignition is ON.

•	The TCM has determined that a non-emissions related malfunction exists.

Conditions for Setting the DTC

The ECM is requesting an SVS message on the DIC.

Action Taken When the DTC Sets

•	The control module stores the DTC information into memory when the diagnostic runs and fails.

•	The malfunction indicator lamp (MIL) will not illuminate.

•	The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.

•	The driver information center, if equipped, may display a message.

Conditions for Clearing the DTC

•	A current DTC Last Test Failed clears when the diagnostic runs and passes.

•	A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.

•	Clear the DTC with a scan tool.

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check-Engine Controls?	Go to Diagnostic System Check - Automatic Transmission in Automatic Transaxle - AF23-5 or Diagnostic System Check - Automatic Transmission in Automatic Transmission - VT25-E	Go to Diagnostic System Check - Engine Controls