The Power Steering Control Module (PSCM) receives a class 2 power moding message from the Body Control Module (BCM) to determine the position of the ignition switch. After a power mode OFF message is received, the PSCM monitors the ignition 1 voltage circuit to detect if a short to voltage fault exists.
• | The ignition is OFF. |
• | The class 2 power mode message indicates OFF. |
• | The PSCM ignition 1 voltage circuit is shorted to voltage. |
• | DTCs U1300 and U1301 are not set. |
• | DTC C0848 is stored in memory. |
• | The IPC message center displays the PWR STR warning message. |
• | A current DTC will clear on the next consecutive malfunction free ignition cycle. |
• | A history DTC will clear after 100 consecutive malfunction free ignition cycles. |
• | Using a scan tool |
Step | Action | Yes | No |
---|---|---|---|
Connector End Views Reference: Power Steering Connector End Views | |||
1 | Did you perform the Power Steering Diagnostic System Check? | Go to Step 2 | |
2 | Test the ignition 1 voltage circuit for a short to voltage. Refer to Testing for a Short to Voltage and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
3 |
Does the DTC reset? | Go to Step 2 | System OK |