GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2004 🢒 ION 🢒 Accessories 🢒 Cruise Control 🢒 Cruise Control Module Replacement

Removal Procedure

    Object Number: 329483 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  2. Disconnect the cruise control module harness connector .
  3. Disconnect the cruise control cable from the cruise control module by turning the cable ¼ turn counterclockwise.

    4. Object Number: 854297 Size: SH
  4. Disconnect the cruse control cable (1) from the accelerator pedal.
  5. Remove the nuts (2) from the cruise control module.
  6. Remove the cruse module from the vehicle.

Installation Procedure
  1. Position the cruise control module to the mounting bracket.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 854297 Size: SH
  2. Install the cruse control module to bracket nuts (2).

    3. Tighten
    Tighten the nuts to 10 N·m (89 lb in).

  3. Connect the cruise control cable to the accelerator pedal.

    4. Object Number: 293672 Size: SH

    Important: The ribbon must not be twisted.

  4. Connect the cruise control cable (2) to the cruise control module ribbon (4).

    5. Object Number: 325857 Size: SH
  5. Insert the cruise control cable into the cruise control module until the seal touches the module.

    6. Object Number: 329483 Size: SH
  6. Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.

    7. Important: The adjuster tab must be pointing toward the front of the car after installation.

  7. Connect the cruise control cable to the cruise control module by turning the cable clockwise.
  8. Connect the cruise control module harness connector.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.