Clutch Actuator Cylinder Replacement Getrag 5 Speed

1. Disconnect the clutch actuator cylinder line.
2. Remove the transmission. Refer to Transmission Replacement in Manual Transmission -  M86/M94 Getrag.



3. Remove the clutch actuator cylinder bolts from the transmission.



4. Remove the following components from the transmission:

•	The upper bolt

•	The clutch actuator cylinder

Important: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.

1. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
2. Install the clutch actuator cylinder to the transmission.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the clutch actuator cylinder bolts

Tighten
Tighten the bolts to 10 N·m (89 lb in).




4. Install the upper line release bolt.

Tighten
Tighten the bolt to 10 N·m (89 lb in).

5. Install the transmission. Refer to Transmission Replacement in Manual Transmission - M86/M94 Getrag.



6. Connect the clutch actuator cylinder line.
7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding .

Clutch Actuator Cylinder Replacement MU3

1. Remove the transaxle. Refer Transmission Replacement .
2. Remove the hydraulic line from the slave cylinder.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the slave cylinder. Use LOCTITE 592® P/N 21485278 thread sealant on the screws.

Tighten
Tighten the slave cylinder fasteners to 10 N·m (89 lb in).

2. Connect the hydraulic line to the slave cylinder.
3. Bleed the slave cylinder. Refer to Hydraulic Clutch Bleeding .
4. Install the transaxle. Refer to Transmission Replacement .