For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front wheels. Refer to Tire and Wheel Removal and Installation .
- Remove the rear transaxle mount. Refer to the following:
- Remove the steering gear. Refer to Steering Gear Replacement .
- Disconnect the stabilizer links from the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
- Remove the stabilizer bar mounting clamp bolts and clamps from both sides of the vehicle.
- Remove the bushings from the stabilizer bar.
- Lift and rotate the stabilizer bar up and to the right.
- Carefully remove the stabilizer bar from the right side of the vehicle.
| • | Transmission Rear Mount Replacement for the Getrag 5 Speed transmission. |
| • | Transmission Rear Mount Replacement for the MU3 transmission. |
| • | Transmission Rear Mount Replacement for the 4T45-E transaxle. |
Installation Procedure
- Move the stabilizer bar into position from the right side of the vehicle.
- Install the stabilizer bushings on the stabilizer bar with the cut line facing rearward.
- Install the stabilizer bar clamps and bolts.
- Connect the stabilizer links to the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
- Install the steering gear. Refer to Steering Gear Replacement .
- Install the rear transaxle mount. Refer to the following:
- Install the front wheels. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 50 N·m (37 lb ft).
| • | Transmission Rear Mount Replacement for the Getrag 5 Speed transmission. |
| • | Transmission Rear Mount Replacement for the MU3 transmission. |
| • | Transmission Rear Mount Replacement for the 4T45-E transaxle. |
