GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Approved Equipment for Collision Repair Caution in the Preface section.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  3. Remove all related panels and components.
  4. Repair as much of the damaged area as possible. Refer to Dimensions - Body .
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  6. Important: Note the number and location of the factory welds for installation of the rocker panel reinforcement-inner.


    Object Number: 870918  Size: SH
  7. Locate and drill out all the necessary factory welds.

  8. Object Number: 870919  Size: SH
  9. Remove the rocker panel reinforcement-inner.

Installation Procedure


    Object Number: 870917  Size: SH

    Important: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1 1/2 in) apart.

  1. Drill 8-mm (5/16-in) plug weld holes in the service part as necessary in the locations noted from the original panel.
  2. Prepare all mating surfaces for welding as necessary.
  3. Apply 3M® Weld-Thru Coating P/N 05916 or equivalent to all mating surfaces.

  4. Object Number: 870919  Size: SH
  5. Position the rocker panel reinforcement-inner on the vehicle. Clamp the panel in place.

  6. Object Number: 870918  Size: SH
  7. Plug weld accordingly.
  8. Clean and prepare all of the welded surfaces.
  9. Install all of the related panels and components.
  10. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
  11. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems in Paint and Coatings.
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  13. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.