For 1990-2009 cars only
Removal Procedure
- Pull out on the accessory trim plate in order to release the retaining fasteners.
- Disconnect the electrical connectors from the accessory trim plate.
- Remove the screws from the radio and pull the radio out.
- Disconnect the radio electrical connectors and remove the radio.
Installation Procedure
- Place the radio in the vehicle and connect the radio electrical connectors.
- Push the radio into position and install the screws.
- Connect the electrical connectors to the accessory trim plate.
- Align the retaining fasteners with the instrument panel.
- Set up the radio. Refer to Control Module References for programming and setup information.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.
