For 1990-2009 cars only
Removal Procedure
- Remove the clutch pedal retainer from the front of the clutch pedal assembly.
- Pull the clutch pedal upward in order to disengage the clutch master cylinder pushrod from the clutch pedal.
- Remove the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
- Place a shop towel under the clutch master cylinder in order to catch any fluid loss.
- Disconnect the clutch damper from the clutch master cylinder.
- Disconnect the reservoir line from clutch master cylinder.
- Cap the reservoir and hydraulic lines in order to prevent fluid loss and contamination.
- Rotate the clutch master cylinder one 1/4 turn clockwise and remove the cylinder from the vehicle.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.
Installation Procedure
- Install the clutch master cylinder while rotating 1/4 turn counterclockwise.
- Uncap the reservoir and hydraulic lines.
- Connect the clutch damper to the clutch master cylinder.
- Install the reservoir line in the clutch master cylinder.
- Remove the shop towel and discard in a suitable container.
- Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
- Connect the clutch master cylinder pushrod to the clutch pedal.
- Install the clutch pedal retainer.
- Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
Important: While installing, ensure that the clutch master cylinder pushrod is aligned with the clutch pedal.
