Notice: Do not pull on the edges of the center high-mounted stop lamp cover. Damage to the cover may result. Slide your fingers between the cover and the lamp, and carefully pull the cover down.

1. Remove the center high-mounted stop lamp cover.
2. Disconnect the electrical harness only if you are removing the center high-mounted stop lamp.
3. If you are removing the bulbs, twist the sockets out of the stop lamp. Remove the bulbs.



4. Remove the center high-mounted stop lamp retainer screws.
5. Remove the center high-mounted stop lamp from the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




1. Install the center high-mounted stop lamp with screws.

Tighten
Tighten the center high-mounted stop lamp screws to 2.5 N·m (19 lb in).

2. Connect the electrical connector to the center high-mounted stop lamp.



3. Install the cover by placing the tabs in the slots. Gently press the cover into place.